Dear Tom
I tried your tmap file and send the reset fuse command,but the fuse failure condition didn't clear.
The test method is use bqwizard SBD Read/Write Utility to write the 200B(HEX) to 0x80.
If this method test pass, I can use MCU to send the command to clear fuse failure condition.
All the command was refered the SLUSAB8B and SLUA591.
Sorry, I had another question need your help.
If I want to send the reset fuse/power pump disable/power pump disable commands, do i need send the unlock command for these operation?
Thanks!
BR
Edison