thank for reply
because my circuit isn't the EVM. I think there are maybe some problems on the circuit
I list my questions follwing
1.I don't know how to connect the circuit to battery and the charger. so I connect battery+ to BAT+, battery- to
BAT- and BAT- connect to ground . And the charger + I conect to battery+ ,the charger- I connect to PACK-
and I am not sure that when the battery is connected, should I start the charger that the IC will work as
normally?
2.because I couldn't find the 0.01 ohm sense resistor ,so I used two 0.2 ohm resistor parallel to create 0.1 ohm
,I am not sure it is OK or not.
3.And the AZ23C5V6-7 diode,i didn't use it. I take 5.6V zener replacing it ,is it ok?
4.I connect the circuit to bqEVSW through EV2300 ,it shows No communication with EVM Gas gauge could be
established. how could I do?
Thanks. LYS
