What is the reason for the OCP triggering with such a small load (120 mA) and with this type of MOSFET (about 9 miliohm)? Which calibration voltages do you mean? On ENSS pin, there can be seen the calibration after power on at 1,3 V for about 2 ms. The DC voltage is due to the short time of power off, when I measured the waveforms on the pins after startup. Is there a need for the ENSS pin voltage to go below 270 mV to ensure a restart even if the input voltage goes to the zero (manuall shorting of the input capacitor after power off)?
↧