Hi.
I am using the LM5104 to drive an half bridge with an inductive load, whose schematic is attached.
The main problem is a strong swinging on the load voltage. I have experienced the same problem
by changing the layout of the PCB many times, by using different resistors connected to the RT pin,
and different sizes of the bootstrap capacitor. I also tried to use an external "optional" recovery
bootstrap diode, and this increases the swinging really a lot. Moreover, the swinging has a fixed
frequency of 14 MHz which I can not really explain.
Any suggestions on how to improve the circuit behaviour, as at the moment it is not useful at all ?
Thanks